FAQ: re my question How do I fit an antique light fitting?
Question by Anne B: re my question How do I fit an antique light fitting?
I think folk are misunderstanding. The point is that I need to wire the new two wired cable into the existing junction boxes on the ends of the wires in the ceiling. I know how to wire a normal three wire fitting into the light (like the fitting I have removed) but was just asking what to do about the earth cable in the ceiling. Do I need to earth that or will it be ok just to leave?
Normally, the modern rose would have an earth in it but because the antique rose doesn’t involve any wiring (you just feed the cable through), I was slightly worried about not earthing anything.
so, thnks to all who advised an electrician. An electrician won’t be necessary – just a bit of advice about the earth cable, please.
Best answer:
Answer by wrathofkublakhan
You can ground to the junction box. The conduit is considered a ‘run to ground.’
If there is a switch, then the hot should run through the switch — continue to the light bulbs and then the neutral takes it back.
Give your answer to this question below!